LACWRKPROTSHT-CLEAR-0,15X2M| Details please find in product description
Paint protection film – polyurethane-based
Simple self-assembly and disassembly with overall thickness of 0.36 mm
Acrylate adhesive in conjunction with Würth assembly fluid
Simple self-assembly:
Before application, thoroughly clean the paint surface to be adhered of grease and dust; remove any paint polish. Lay in a location that is protected from wind, dust and direct sunlight. Only glue Würth paint protection film when wet. Do not apply to freshly painted surfaces!
Simple disassembly:
Starting from any corner, the Würth paint protection film can be removed in a single piece without leaving any residue. It is advisable to warm the relevant corner slightly with a hair dryer so that it is easier to grip.
1. Cut the Würth paint protection film to the required size. Intended for license plate lights, key holes, fog lights etc. with corresponding cut-outs. First tape over the cut-out for license plate lighting etc., use a pen to mark the cut-out on the paint film, remove the paint protection film, and cut out the marked hole with scissors.
2. Remove the backing paper. Generously moisten the adhesive film side and the paint surface to be glued with Würth assembly fluid (spray bottle). Position the paint protection film. The film can be stretched without deforming around curves and corners. Using a blade, spread the assembly fluid in overlapping lines, working from the inside outwards.
3. However, if there are still air or water bubbles, remove as much of the paint protection film as is necessary, spray again with assembly fluid and repeat the process. With any folds, lightly heat up with a hair dryer and smooth the film using a blade.
The paint protection film can be used on all paint areas (cars, trucks, buses, motorbikes etc.) particularly at risk, e.g. bumpers, bonnets, wheel trims, mudguards, door sills etc.
Please note that the paint protection film must only be used in conjunction with Würth assembly fluid. Only when this liquid is used can optimum assembly, a permanent hold and residue-free removal be guaranteed.
Optimum bonding of the film with the surface is reached after approx. 48 hours. Until this point, do not attempt to adhere anything or expose the glued paint protection film to major stresses (such as car wash facilities, steam jets etc.).
Your klickparts points will be converted into a voucher. Only the points used will be deducted. If the net value of the goods is less than the voucher, the remaining points will be retained.
Simply click on "Redeem now".
Loading
Loading
