FILR-(SPLICES-FACES)-LIGHTGREY-10LTR | Details please find in product description
Light filler
Ready for use
Cracks do not form as shrinkage is low
Extremely supple and easy to sand
Environmentally friendly
WLF joint and surface filler is applied with a steel spatula at a minimum temperature of +5°C. Then lay the fibreglass reinforcement strips (art. no. 0992500001) in the fresh filler and subsequently spread over it. The surface must be clean, load-bearing and dry. Maximum coat thickness: approx. 5 mm. Note the risk of discolouration through e.g. rust, nicotine, formwork oil or other similar substances. An insulating primer layer must be applied here. Wear a fine-dust mask when sanding. Thoroughly remove all dust from the sanded surface before applying wallpaper or paint.
Material consumption:
Filling and grouting gypsum plasterboards in dry indoor construction and for walls and ceilings, and for indoor plastering with concrete, aerated concrete and sand-lime brick surfaces. Also ideal for surface filling.
As it is not resistant to abrasion, we advise against using as a final coating or in damp rooms.
Store WLF joint and surface filler in a cool, but frost-free place. Do not expose to direct sunlight.
Your klickparts points will be converted into a voucher. Only the points used will be deducted. If the net value of the goods is less than the voucher, the remaining points will be retained.
Simply click on "Redeem now".
Loading
Loading
